CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Exporting ANSYS mesh to FLUENT (http://www.cfd-online.com/Forums/fluent/45283-exporting-ansys-mesh-fluent.html)

peksen July 6, 2007 10:33

Exporting ANSYS mesh to FLUENT
 
I created a 3D model in ANSYS 9 with elements 142-143 i.e. it is a 4 layer structure. I first subtracted all layers from an air domain. one layer has to be a porous layer , therefore I created this layer again inside the emptied place to retain the volume and treat it as porous in FLUENT. The problem is: After I exported and opened it in FLUENT, The layers are completely there. But there is only one zone instead of 4. Therefore I can not give initial values via patching temperatures, because the zones are not there. How can I manage this, can naybody help? regards

--------------------------------------------------------------------------------



All times are GMT -4. The time now is 13:57.