CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Gambit Setup for Remeshing (http://www.cfd-online.com/Forums/fluent/45307-gambit-setup-remeshing.html)

Bob Carson July 9, 2007 13:28

Gambit Setup for Remeshing
 
I am setting up a case in Gambit and I am trying to define the zones where the remeshing is occuring. Are these defined as interfaces? Should each zone have separate vertexes and lines? This is a 2D case.

Endee July 10, 2007 06:59

Re: Gambit Setup for Remeshing
 
You just define them as different 'continum type' by selecting the moving zone and then rest of the domain.

Note that (In Fluent) if you are defining it through a profile, then you need to select these zones as per the profile you have already read to specify the motion.

Hope that helps.


All times are GMT -4. The time now is 02:59.