|
[Sponsors] |
July 9, 2007, 16:44 |
coating
|
#1 |
Guest
Posts: n/a
|
Hi,
I'm trying to mesh two thin solid layers (coating) around a blade. I tried to model the two thin solid volumes and mesh them, but without success. On the other hand I can create a uniform hex b.l. mesh around the blade as part of the flow domain, so I was thinking is it possible to define two portions (layers) of that b.l. mesh as solid? Thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fluent doesnt read 1D coating mesh - advice needed | FuzzyDice | FLUENT | 5 | September 28, 2011 17:34 |
the volatilization after coating the paint | Jay | FLUENT | 1 | March 2, 2005 04:36 |
spin coating | JH | FLUENT | 0 | July 23, 2004 21:32 |
Modelling of Filter paper and paint coating | Karthick | FLUENT | 0 | June 8, 2004 08:14 |
Modelling of Filter paper and paint coating | Karthick | FLUENT | 0 | June 2, 2004 07:20 |