|
[Sponsors] |
July 9, 2007, 14:28 |
Gambit Setup for Remeshing
|
#1 |
Guest
Posts: n/a
|
I am setting up a case in Gambit and I am trying to define the zones where the remeshing is occuring. Are these defined as interfaces? Should each zone have separate vertexes and lines? This is a 2D case.
|
|
July 10, 2007, 07:59 |
Re: Gambit Setup for Remeshing
|
#2 |
Guest
Posts: n/a
|
You just define them as different 'continum type' by selecting the moving zone and then rest of the domain.
Note that (In Fluent) if you are defining it through a profile, then you need to select these zones as per the profile you have already read to specify the motion. Hope that helps. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sliding mesh setup for a mixing tank in Gambit | nycera | FLUENT | 13 | October 11, 2016 15:39 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 01:27 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 13:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 09:33 |
Athlon 64 Gambit Compatibility? | Derick | FLUENT | 3 | January 17, 2006 18:28 |