|
[Sponsors] |
August 2, 2007, 03:16 |
urget help need plz!
|
#1 |
Guest
Posts: n/a
|
hi i have made blade profile by entering coordinates in gturbo and i want to ask that after describing required vertex on blade profile .the error is that the blade tip is not connected and how the profile edge continuity is achieved in blade. thanks in advance
|
|
August 2, 2007, 04:58 |
Re: urget help need plz!
|
#2 |
Guest
Posts: n/a
|
Hi, where the command in its turbo file profile edge connectivity can be found out?
|
|
August 2, 2007, 11:31 |
Re: urget help need plz!
|
#3 |
Guest
Posts: n/a
|
Probably the vortex or lines are not connected.
Try this. Geometry: vortex-->connect vortices--> all --> apply. Check in the command window whether some vortices are connected. Do the same with lines. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I need a guideline for FLUENT!! plz.. | ruzfactor | FLUENT | 2 | November 19, 2010 12:06 |
plz help its urgent | garima chaudhary | FLUENT | 0 | September 25, 2007 05:28 |
plz help | sameera | Main CFD Forum | 7 | August 10, 2007 18:16 |
plz ......help me out.....************************ | krishna | FLUENT | 2 | January 10, 2007 02:53 |
How to export from Acad into gambit plz! | pah | FLUENT | 2 | April 28, 2005 01:50 |