CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Polyhedral mesh in Fluent (http://www.cfd-online.com/Forums/fluent/45639-polyhedral-mesh-fluent.html)

Shri August 7, 2007 09:10

Polyhedral mesh in Fluent
 
hai friends i have a doubt that is polyhedral meshing is availabel in Gambit or in ICEM CFD . Please send me some article link if possible.

regards shri

nino August 8, 2007 01:35

Re: Polyhedral mesh in Fluent
 
Polyhedral isn't available in Gambit. You can only convert your tetrad mesh into polyhedral within fluent 6.3.x (it is just embedded in fluent, not in gambit)

red lemon August 8, 2007 13:53

Re: Polyhedral mesh in Fluent
 
You can also export a mesh as a polyhedral type from TGrid but this is for hexcore to convert the transitional cells. All cells will be tagged as a polyhedral type however. This is to avoid hanging nodes but these meshes cannot be read back in to TGrid/Gambit once converted.

majid August 22, 2007 04:31

Re: Polyhedral mesh in Fluent
 
hello. I need automobile mesh in fluent or address in internet thankful


All times are GMT -4. The time now is 04:00.