|
[Sponsors] |
icem 3d mesh for compressible flow with combustion |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 3, 2007, 11:46 |
icem 3d mesh for compressible flow with combustion
|
#1 |
Guest
Posts: n/a
|
Hi All,
Has anyone created a tetra mesh in icemcfd 11.0 for compresible flow simulation with combustion in Fluent? I have done it but i keep having problems with convergence. For the cold flow, the steady flow residuals drops nicely and but when i switch to hot flow, the residuals begin to fluctuate......it is not the case if it is incompressible. The residuals for the fuel especially are showing sharp fluctuations. Any thoughts on why this is happening? Counting on your assistance. Jimmy |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
problem when converting mesh (made by ICEM) using fluentMeshToFoam | Forrest_Lei | OpenFOAM | 11 | October 16, 2009 06:28 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |