|
[Sponsors] |
September 3, 2007, 08:36 |
About Residual Convergence
|
#1 |
Guest
Posts: n/a
|
What's the difference between the Absolute Criteria in Residual Monitor and the Residual in the Display Menu?
I just started studying on Fluent. And now I'm working on laminar flow. When I set the Absolute Criteria as 10e-5 for continutity, it could never been there, but after 3000 interactions, I used the display->contour->redisual->mass imbalance, it showed that the biggest residual was just in 10e-9 order. Why? How can I set the residual convergence properly? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 06:54 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |