I'm using nonconformal grid in a Fluent case. It worked when I was using one single computer, but failed when I tried to put them into parallel calculation. Can anyone tell me how to solve this problem?

Thanks so much.

I AM JAI SHANKAR V P . I AM CURRENTLY WORKING AS SENIOR LECTURER WITH SNMIMT IN INDIA .I AM CURRENTLY COMPLEATING MY MASTERS IN PRODUCTION ENGINEERING WITH COCHIN UNIVERSITY OF SCIEANCE AND TECHNOLOGY , KOCHI, KERALA , INDIA

I AM VERY INTRESTED IN THE SUBJECT OF CFD .

CAN I GET ANY HELP FORM YOU IN THE SAME . MY EMAIL ID IS shankarvp@yahoo.co.in

HOPE U WILL HELP ME INTHIS ISSUE

WITH REGARDS

JVP

Hi,

If memory serves, the problem has to do with the segmentation of the mesh for parallel distribution across a non-conformal boundary. Fluent 6.3 does this properly, I think, but 6.2 had issues. If you're trying this under fluent 6.3, I think a little more information about your specific case would help in determining the difficulty. This can be made to work under Fluent 6.2, but I think you need to carefully segment the mesh such that either the entire non-conformal interface is within one chunk of the mesh, or that the mesh segments perfectly match the non-conformal interface. I may be off on this-- somebody please correct me if I am. Hope this helps...

Andy

Continue to post this crap and your IP will be banned, permanently.

Hey, Jai Why are you so shameless? Can you not understand that nobody is going to teach you CFD. There is a lot of resources in the internet for learning. Just search and read those materials or take a course on CFD in your institute. As a Lecturer, don't humiliate yourself.

i work under fluent 6.2