CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   FLUENT (https://www.cfd-online.com/Forums/fluent/)
-   -   polyhedral mesh conversion (https://www.cfd-online.com/Forums/fluent/46028-polyhedral-mesh-conversion.html)

ali September 14, 2007 03:54
polyhedral mesh conversion
 
hi all,

i am trying to convert tetrehedral mesh to polyhedral,i have used 10^6 cell and fluent gives out of memory warning but i have 26 GB free disk space. how i can solve this problem. thanks

Rasmus Jensen September 14, 2007 05:10
Re: polyhedral mesh conversion
 
Hi Ali

I think you run out of RAM, I would think that you should use around 2GB of ram to make that operation, including your swap.

This is only if it is a windows mashin you are running, as it is the only I have experience with.

Best regards, Rasmus Jensen

ali September 14, 2007 06:07
Re: polyhedral mesh conversion
 
thank you a lot Rasmus Jensen

philipov September 14, 2007 08:27
Re: polyhedral mesh conversion
 
Definitely RAM is the problem: More RAM=More power :)

ali September 14, 2007 11:55
Re: polyhedral mesh conversion
 
thank you philipov,i just try to increase RAM


All times are GMT -4. The time now is 06:45.