 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2007, 03:54
|
polyhedral mesh conversion
|
#1 |
|
Guest
Posts: n/a
|
hi all,
i am trying to convert tetrehedral mesh to polyhedral,i have used 10^6 cell and fluent gives out of memory warning but i have 26 GB free disk space. how i can solve this problem. thanks |
|
|
||
|
September 14, 2007, 05:10
|
Re: polyhedral mesh conversion
|
#2 |
|
Guest
Posts: n/a
|
Hi Ali
I think you run out of RAM, I would think that you should use around 2GB of ram to make that operation, including your swap. This is only if it is a windows mashin you are running, as it is the only I have experience with. Best regards, Rasmus Jensen |
|
|
|
||
|
September 14, 2007, 06:07
|
Re: polyhedral mesh conversion
|
#3 |
|
Guest
Posts: n/a
|
thank you a lot Rasmus Jensen
|
|
|
|
||
|
September 14, 2007, 08:27
|
Re: polyhedral mesh conversion
|
#4 |
|
Guest
Posts: n/a
|
Definitely RAM is the problem: More RAM=More power
|
|
|
|
||
|
September 14, 2007, 11:55
|
Re: polyhedral mesh conversion
|
#5 |
|
Guest
Posts: n/a
|
thank you philipov,i just try to increase RAM
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
| mesh conversion for dispersed liquid drop flowing upward in a continous phase | hossein.mashhadi | OpenFOAM Running, Solving & CFD | 0 | February 3, 2011 16:42 |
| mesh conversion for dispersed liquid drop flowing upward in a continous phase | hossein.mashhadi | OpenFOAM | 0 | February 2, 2011 10:43 |
| [Commercial meshers] Mesh conversion from Ansys ICEM | fabian_korn | OpenFOAM Meshing & Mesh Conversion | 3 | February 24, 2010 08:19 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Linear Mode
