UDM - problem!!!!

September 4, 2007, 11:32

Hi all! I am using FLUENT 6.1.22. I have to simulate the evolution of porosity and permeability in time and to do this I have prepared two UDF's and I store the values in 2 UDM's. The problem is that my domain has more than 500 cells, and the UDM memorizes only up to 500 values... How can I do? Thanks and all the best

Giacomo

September 16, 2007, 20:25

Its not that UDM memorises 500 values. IF u read the manual U can have up to 500 UDMs and each UDM can save sufficient number of values. So use the UDM without worrying abt its memory capacity. Hope this helps.

September 4, 2007, 11:32	UDM - problem!!!!	#1
Giacomo Guest Posts: n/a	Hi all! I am using FLUENT 6.1.22. I have to simulate the evolution of porosity and permeability in time and to do this I have prepared two UDF's and I store the values in 2 UDM's. The problem is that my domain has more than 500 cells, and the UDM memorizes only up to 500 values... How can I do? Thanks and all the best Giacomo

September 16, 2007, 20:25	Re: UDM - problem!!!!	#2
Ash Guest Posts: n/a	Its not that UDM memorises 500 values. IF u read the manual U can have up to 500 UDMs and each UDM can save sufficient number of values. So use the UDM without worrying abt its memory capacity. Hope this helps.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52