Home > Forums > Software User Forums > ANSYS > FLUENT

Time step too small in stiffbs

Updated Threads

Reply

Search this Thread

September 19, 2007, 22:59	Time step too small in stiffbs	#1
Zhigang Hu Guest Posts: n/a	Hi, everyone. The following message appears when I activate the heat mass coupling in DPM panel. "Time step too small in stiffbs: dt = 8.537147e-021, t = 0.000000e+000 0 y = 7.000001e-006 dy/dt = 0.000000e+000 1 y = 1.000000e+020 dy/dt = 0.000000e+000" Can you explain it?Thank you very much! Zhigang Hu

September 22, 2007, 06:55	Re: Time step too small in stiffbs	#2
Zhigang Hu Guest Posts: n/a	HELP!HELP!HELP!HELP!HELP!HELP!

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
How to write k and epsilon before the abnormal end	xiuying	OpenFOAM Running, Solving & CFD	8	August 27, 2013 15:33
very small time step in GMO model	shyam	FLOW-3D	1	December 12, 2011 00:26
Differences between serial and parallel runs	carsten	OpenFOAM Bugs	11	September 12, 2008 11:16
AMG versus ICCG	msrinath80	OpenFOAM Running, Solving & CFD	2	November 7, 2006 15:15

All times are GMT -4. The time now is 08:38.