|
[Sponsors] |
September 19, 2007, 06:43 |
non-positive surfaces
|
#1 |
Guest
Posts: n/a
|
I am solving a 2-d axisymmetric flow. when i import my mesh to fluent, it gives an error saying as "non-positive surfaces exists"
can anybdy tell me how to go abt.. it. bye thanks in advance |
|
September 20, 2007, 10:37 |
Re: non-positive surfaces
|
#2 |
Guest
Posts: n/a
|
Use gambit check faces geometry and topology to see if any of the faces fail the check. If they do that's what causes the non-positive surfaces. Also in the tools panel you can check for faces with very small areas and fix any of those which have very small area compared to the rest. If all these are OK and you still have problems - try reading in 2ddp instead of 2d. Hope this helps.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to get forces on Iso-Clip Surfaces and How to get forces in cylindrical coordinat | CFD XUE | FLUENT | 3 | March 18, 2015 03:28 |
Importing or Creating 2D Flat Surfaces into CFX | Sam | CFX | 5 | March 30, 2013 11:11 |
Exporting surfaces inside the control volume (interior) | bigmoneylou | ANSYS Meshing & Geometry | 1 | January 8, 2011 16:16 |
Faceted surfaces in ICEM | Chriss | Main CFD Forum | 1 | May 6, 2008 15:18 |
Surfaces | Mark | FLUENT | 2 | February 9, 2004 10:41 |