|
[Sponsors] |
September 20, 2007, 01:16 |
Create Zones in Fluent
|
#1 |
Guest
Posts: n/a
|
I made the whole flow domain in Gambit to be a single zone. Is it possible to subdivide this zone within Fluent? I have run the analysis, adaptation etc. and don't want to go back to Gambit again.
|
|
September 20, 2007, 10:34 |
Re: Create Zones in Fluent
|
#2 |
Guest
Posts: n/a
|
Sorry to bring you bad news ...but you can't separate fluid zones in fluent. It needs to be done in Gambit.
|
|
September 20, 2007, 14:11 |
Re: Create Zones in Fluent
|
#3 |
Guest
Posts: n/a
|
You can "MARK" (NOT adapt) the zone you want in the adapt menu and then got to grid>separate>cells and use the marker to separate the cells. Make sure to save your work before doing this. I have seen it crashed sometimes.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to create non-uniform velocity profile in FLUENT? | pankaj | FLUENT | 7 | October 24, 2016 04:52 |
Ansys 12.1 - Create Rotor/Stator Interface for Fluent | opm | ANSYS Meshing & Geometry | 21 | May 23, 2016 08:29 |
Fluent jobs through pbs | ibnkureshi | FLUENT | 5 | June 9, 2011 13:43 |
difficulties to create a movie under Fluent | jjchristophe | FLUENT | 5 | March 11, 2010 01:24 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |