Invalid Upper Topology

September 22, 2007, 10:58

Hello,

I am having problems meshing a particular volume in Gambit. It keeps saying that:

ERROR: Face 61 is missing egde edge.177 in lower topology list ERROR: Coedge for face 61 and edge 177 is missing or corrupt Meshing volume aborted because it has invalid topology

What does this mean please? I have tried simplifying my geometry, all other volumes mesh fine it's just face 61 and edge 177 which seem to be causing problems.

Thanks a lot

October 5, 2007, 13:45

thank you

September 22, 2007, 10:58	Invalid Upper Topology	#1
Naghman Khan Guest Posts: n/a	Hello, I am having problems meshing a particular volume in Gambit. It keeps saying that: ERROR: Face 61 is missing egde edge.177 in lower topology list ERROR: Coedge for face 61 and edge 177 is missing or corrupt Meshing volume aborted because it has invalid topology What does this mean please? I have tried simplifying my geometry, all other volumes mesh fine it's just face 61 and edge 177 which seem to be causing problems. Thanks a lot

October 5, 2007, 13:45	Re: Invalid Upper Topology	#2
farouk Guest Posts: n/a	thank you

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh	gschaider	OpenFOAM Community Contributions	300	October 29, 2014 18:00
Volume 1 has invalid topology for mapped brick meshing	georgewar	ANSYS	0	July 24, 2011 16:02
OpenFOAM install on Ubuntu Natty 11.04	bkubicek	OpenFOAM	13	May 26, 2011 05:48
Phase locked average in run time	panara	OpenFOAM	2	February 20, 2008 14:37
error: invalid topology	julie	FLUENT	2	July 20, 2004 16:46