Home > Forums > Software User Forums > ANSYS > FLUENT

extending boundary layer to mesh faces

Mark Forums Read

Reply

Search this Thread

September 28, 2007, 03:26	extending boundary layer to mesh faces	#1
kb Guest Posts: n/a	Hi I have enquiry in drawing the grid for a 3D pipe with boundary layer. I want know how i can divide the boundary layer into nodes then extending it to mesh the faces of the pipe? Is there anybody have idea about doing this? THanks for any suggestions kb

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Creating Hex Boundary Layer Mesh and Unstructured everywhere else	NLao	ANSYS Meshing & Geometry	1	March 15, 2011 06:35
Not able to mesh a helix with boundary layer using gambit	rohitjvbibin	FLUENT	1	March 7, 2011 04:40
[snappyHexMesh] Boundary layer generation problems	ivan_cozza	OpenFOAM Meshing & Mesh Conversion	0	October 6, 2010 13:47
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 06:47.