 |
 |
 |
|
|
|
[Sponsors] | ||||
September 29, 2007, 11:53
|
What is hydraulic diameter and reference value?
|
#1 |
|
Guest
Posts: n/a
|
Hello, can anybody tell me what is hydraulic diameter? if i am simulating a 2 dimensional air flow simualtion around a 4.465m length and 1.42m heigh car in a 60 x 35 meter square wind tunnel, what hydraulic diameter should i set? what are the area and length values should i set in the reference value? thanks.
|
|
|
||
|
October 1, 2007, 09:59
|
HELP please! urgent.
|
#2 |
|
Guest
Posts: n/a
|
Hello, can anybody tell me what is hydraulic diameter? if i am simulating a 2 dimensional air flow simualtion around a 4.465m length and 1.42m heigh car in a 60 x 35 meter square wind tunnel, what hydraulic diameter should i set? what are the area and length values should i set in the reference value? thanks.
|
|
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Questions regarding Particle Tracking and Rotating Frame of reference | Maxime Gauthier | CFX | 1 | May 9, 2011 15:07 |
| Axisymmetric Reference Area | jack1980 | FLUENT | 0 | October 16, 2009 09:34 |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 18 | October 2, 2009 04:18 |
| Reference values set up Plz help! | pah | FLUENT | 0 | June 14, 2005 06:39 |
Linear Mode
