CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Problem with 2D ICEM mesh check in fluent (http://www.cfd-online.com/Forums/fluent/46235-problem-2d-icem-mesh-check-fluent.html)

Nicola October 5, 2007 05:19

Problem with 2D ICEM mesh check in fluent
 
Hello everyone! I created a 2D mesh in ICEM but when I import it in fluent 6 I have a warning during check mesh: "mesh has negative volumes!" What's the problem? If someone can help me I thank him very much.


Greg October 5, 2007 08:55

Re: Problem with 2D ICEM mesh check in fluent
 
It's not a problem of Fluent. It means that your meshing is not good, try to decrease the size of your cells. For 2D meshing I use Gambit but It's the same problem, size of cells too big for your geometry.


Rameche Candane October 11, 2007 03:55

Re: Problem with 2D ICEM mesh check in fluent
 
The size of cells are too small and not too big. Coarsen the mesh near the wall but take care u dont coarsen it too much - for the gradients are quite significant near the wall. Are else create the geometry by specifying the dimensions in mm in ICEMCFD. (its like mentioning for 1mm specify 1000mm or 100cms) try importing it to Fluent and then set the scale in fluent and then do the analysis.

Regards, Rameche

khe March 25, 2013 06:56

simulation's probleme on fluent
 
hello everyone,
i I created a 2D mesh in GAMBIT but when I import it in fluent 6.0 I have a problem: i can't check it ! ! !
the "check"icon isn't accessible
https://mail.google.com/mail/?ui=2&i...f_hepis93b0&zw.
What's the problem?
If someone can help me I thank him very much.


All times are GMT -4. The time now is 20:44.