|
[Sponsors] |
November 2, 2007, 05:40 |
massflow rate specification
|
#1 |
Guest
Posts: n/a
|
Hi friends, For two plane symetric problems (Not axisymetric), in the massflow boundary condition pannel, wheather one need to specify the full flow or 1/4 of the fluid flow. I model 1/4 of the domain.
|
|
November 2, 2007, 15:38 |
Re: massflow rate specification
|
#2 |
Guest
Posts: n/a
|
just the 1/4 of the flow. for example, the mass inflow is definitely 1/4 of the original, and the other parameters may stay the same, such as hydraulic diameter, be careful.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Defining Massflow rate at an angle | vis | CFX | 3 | April 28, 2021 10:50 |
MassFlow Function? Absolute MassFlow? Failure in Caclulation | eRzBeNgEl | CFX | 0 | May 5, 2011 09:46 |
Pressure Drop and Massflow rate issue | M | Siemens | 4 | February 13, 2008 09:12 |
about the massflow rate boundary condition | whitemelon | FLUENT | 0 | June 3, 2006 05:44 |
Mass flow rate specification | Deborah | CFX | 4 | April 1, 2003 13:59 |