 |
 |
 |
|
|
|
[Sponsors] | ||||
November 8, 2007, 00:57
|
Water level at outlet(VOF)
|
#1 |
|
Guest
Posts: n/a
|
hi, i'm doing a free surface simulation in which i need to keep water at a desired height at the outlet What bc shall i use and what parameters shall i specify??
|
|
|
||
|
November 8, 2007, 04:35
|
Re: Water level at outlet(VOF)
|
#2 |
|
Guest
Posts: n/a
|
Hi, if you need to keep the water at a desired heigth at the outlet, you can use the VOF model with the option "open channel". At the outlet, a "pressure outlet" with the open channel option will work. hope that helps
|
|
|
|
||
|
November 12, 2007, 00:40
|
Re: Water level at outlet(VOF)
|
#3 |
|
Guest
Posts: n/a
|
ThANKS the reply.. i'm using fluent 6.1.22 Where do i select this option of open channel??
|
|
|
|
||
|
November 12, 2007, 06:06
|
Re: Water level at outlet(VOF)
|
#4 |
|
Guest
Posts: n/a
|
Go to Define>Model>Multiphase>VOF there you will get this option... for Open channel flow..!
|
|
|
|
||
|
November 12, 2007, 13:46
|
Re: Water level at outlet(VOF)
|
#5 |
|
Guest
Posts: n/a
|
there is no such function for 6.1. only 6.3 has
|
|
|
|
||
|
November 12, 2007, 23:48
|
Re: Water level at outlet(VOF)
|
#6 |
|
Guest
Posts: n/a
|
So whats the remedy in fluent 6.1.2
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| [snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
| height of water level in two-phase flows? | Michael Bo | CFX | 2 | August 23, 2004 01:50 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
| uptodate water distribution network | fredius,magige,tanzanian,(e.a) | Main CFD Forum | 0 | January 27, 2002 07:10 |
Linear Mode
