 |
 |
 |
|
|
|
[Sponsors] | ||||
3D boundary layer limited to flat face groups?? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 9, 2007, 12:45
|
3D boundary layer limited to flat face groups??
|
#1 |
|
Guest
Posts: n/a
|
Can anyone provide some further explanation on the error message "3D boundary layers are limited to flat face groups with END conditions around the boundary"?? Does that imply the problem can be resolved by changing the face vertex type on the corresponding edges??
Thanks! |
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |
| Turbulent Boundary Layer on flat plate | samygero | ANSYS | 2 | May 31, 2011 09:53 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| GAMBIT problem with 3D Boundary Layer when meshing | Anthony Haroutunian | FLUENT | 2 | March 26, 2008 02:02 |
Linear Mode
