DEFINING A SOURCE

November 10, 2007, 09:01

Hi;

I want to define some species mass source through one of my WALL B.Cs. I know the quantity of my source for each face, but I don't know by which macro (DEFINE_?) I can do it?

I know about DEFINE_SOURCE macro but it works for all the domain.

CAN ANYONE GIVE ME SOME ADVICE?

Thanks in advace.

November 12, 2007, 11:09

PLEASE!

November 19, 2007, 05:45

The DEFINE_SOURCE is the correct UDF.

You should obtain the thread of the wall via it's id (visible in boundary condition panel in Fluent). Lookup thread() is the way to obtain it (look Fluent's user Guide). After that you should run a loop over this thread

November 10, 2007, 09:01	DEFINING A SOURCE	#1
Jacob Guest Posts: n/a	Hi; I want to define some species mass source through one of my WALL B.Cs. I know the quantity of my source for each face, but I don't know by which macro (DEFINE_?) I can do it? I know about DEFINE_SOURCE macro but it works for all the domain. CAN ANYONE GIVE ME SOME ADVICE? Thanks in advace.

November 12, 2007, 11:09	Re: COULD ANYONE HELP?	#2
Jacob Guest Posts: n/a	PLEASE!

November 19, 2007, 05:45	Re: DEFINING A SOURCE	#3
Aris Guest Posts: n/a	The DEFINE_SOURCE is the correct UDF. You should obtain the thread of the wall via it's id (visible in boundary condition panel in Fluent). Lookup thread() is the way to obtain it (look Fluent's user Guide). After that you should run a loop over this thread

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 16:02
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 17:18
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 19:08
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24
DecomposePar links against liblamso0 with OpenMPI	jens_klostermann	OpenFOAM Bugs	11	June 28, 2007 17:51