|November 25, 2007, 01:29||
Fluent abrupt behaviour
Hi to all
I am doing simple unsteady state analysis of disc where i am giving boundary conditions as constant heat flux =4000
But if i monitor same value in fluent with the help of fluent monitor it shows me 3691w/m2.
On the other hand when i reach steady state, it shows me heat going outward as 4000w/m2 which is expected.
But it shows heat entering as 3691(Constant value)
|Thread||Thread Starter||Forum||Replies||Last Post|
|Stopping a Fluent batch job AND saving the data! Possible?||Volker Pawlik||FLUENT||7||May 22, 2014 22:30|
|Two questions on Fluent UDF||Steven||Fluent UDF and Scheme Programming||4||September 20, 2013 16:30|
|Compared MRFSimpleFoam and Fluent in a centrifugal pump!||renyun0511||OpenFOAM Running, Solving & CFD||8||July 6, 2010 06:24|
|Fluent 12.0 is worst then Fluent 6.2||herntan||FLUENT||5||December 14, 2009 03:57|
|Problems in lauching FLUENT||Lourival||FLUENT||3||January 16, 2008 17:48|