Creating a new zone in Fluent
Hello, I want to create a new zone of separated cells in Fluent, in which I will input a source term condition, how can I do that ? Thans a lot for your replies.
|
Re: Creating a new zone in Fluent
Firstly mark the region you wnt to separate out using the command
Adapt/region/mark once marked the cells you want to separate...then you can separate them n creat a new zone by grid/separate/cells Hope it serves your purpose..! |
Re: Creating a new zone in Fluent
Ok for that. Now if I want to put a positive mass flow rate (fluid entering the domain) with a constant temperature, how can I define temperature of the fluid ? Do I define the energy of the fluid in W/m3, but how to calculate it ? It is function of a difference of temperature in a time step and in my case there is no variation of the fluid temperature.
|
Re: Creating a new zone in Fluent
Hi
I am not sure of the solution but if you know hoe to define source term then while defining energy you should know that w/m3.0C is specific heat for the fluid so if multiplied by the desired temp. value the resultant unit will be w/m3......! Hope it serves your purpose...but do check with fluent manual..! |
Thank you sushii...it worked perfectly for my case:)
|
All times are GMT -4. The time now is 18:38. |