|
[Sponsors] |
December 17, 2007, 09:27 |
Surface roughness parameters
|
#1 |
Guest
Posts: n/a
|
Hi! I am doing some CFD runs on manifolds - both cast and fabricated. Cast surface is very rough and fabricated is smooth. How do we model this difference in surface roughness? My guess is in Fluent ---> Boundary conditions--->wall-->Momentum---> and specify roughness height and roughness constant. But what values do we specify normally???
Thanks Venu |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CCM+ Surface Roughness | AJ | Siemens | 3 | March 8, 2006 18:14 |
Setting a surface roughness on a wall | Sandile Peta | FLUENT | 3 | February 1, 2006 08:14 |
Modelling free surface waves with wave parameters | utku | FLUENT | 0 | December 6, 2004 08:30 |
surface roughness | sankar | Siemens | 1 | November 8, 2004 10:36 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |