CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

use of Gturbo to make turbine blade

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   December 31, 2007, 06:47
Default use of Gturbo to make turbine blade
  #1
usman
Guest
 
Posts: n/a
Hi, I don't have Gturbo option in my Gambit. I have turbine blade's geometry as radial cuts at three blade heights. Which other software should i use to make a good model. Can i still make it in Gambit. Kindly guide me step by step method to make 3D turbine blade, volume, meshing etc. Any help would be highly appreciated. Many Thanks,
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Mesh a twisted wind turbine blade Laurenjiongo Main CFD Forum 6 January 29, 2018 07:13
[Other] ANSYS CFX-Meshing problem of a wind turbine blade Zoe ANSYS Meshing & Geometry 1 July 14, 2010 03:02
Installation OF1.5-dev ttdtud OpenFOAM Installation 46 May 5, 2009 03:32
Regarding FoamX running Kindly help out hariya03 OpenFOAM Pre-Processing 0 April 18, 2008 05:26
Turbine blade section co-ordinates Iason Hatzitheodorou FLUENT 1 September 26, 2004 23:33


All times are GMT -4. The time now is 06:17.