|
[Sponsors] |
January 14, 2008, 09:34 |
interface
|
#1 |
Guest
Posts: n/a
|
hi every one i want to studie the flow simulations in the stirred tanks for this i use silding mesh but i can't undrestand how i can use interface between stationary and rotating blocks can any one help me thanks
|
|
January 14, 2008, 17:31 |
Re: interface
|
#2 |
Guest
Posts: n/a
|
create a mesh for the rotating part and completely separate mesh for the static part. Each should have a surface mesh for the sliding surface of revolution. Then tmerge together or append grid then define>grid interfaces and set moving fluid as MRF zone.
|
|
January 16, 2008, 04:55 |
Re: interface
|
#3 |
Guest
Posts: n/a
|
thanks for this information I used this way but the velocity of fluid is different of zero only in the rotating zone in the static part the velocity is zero and i want to know what is the difference between moving mesh and moving reference frames thnks any way
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |