|
[Sponsors] |
January 17, 2008, 03:04 |
How to get the facet areas in a plane
|
#1 |
Guest
Posts: n/a
|
I want to calculate the mass flow rate at each cell in fluent in a plane. To do so, i require the 'facet area' normal to the flow direction, say, z-direction.
local mass flow rate = rho*facet_area*Vz How do i do this? I am not looking for surface integrals. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
[CAD formats] my stl surface is seen as just a line | rcastilla | OpenFOAM Meshing & Mesh Conversion | 2 | January 6, 2010 01:30 |
NACA0012 geometry/design software needed | Franny | Main CFD Forum | 13 | July 7, 2007 15:57 |