seza
|
January 27, 2008 13:36 |
radial fan model bc's
hi,
i am modelling the flow inside closed notebook chassis. there is a radial fan in it, and i want to model it as a simple bladeless flow inlet outlet. i know the pressure and flow rate of the fan. i modelled the fan as a 3d block and defined planes for inlet and outlet on that block. i donot mesh inside the fan, just meshed the air inside the chassis. i was trying intake fan and exhaust fan bc's;but this does not work. the mass flow rates of the two planes has to be same i think..
any advice for the bc's? thanks
|