|
[Sponsors] |
January 28, 2008, 04:54 |
dynamic mesh
|
#1 |
Guest
Posts: n/a
|
Hi guys, I am trying to model the dropping of a cap of a solid body.I have five walls describing the whole object which is like a one side open cylinder. I want only three of the walls which describe the cap to move with 6dof and I want the remaining two to stay where they are, however while the cap drops the walls that should remain tends to elongate and after a while run crashes due to detection of negative wolume. I would appreciate it if you could give me some tips for such a case. Thanx in advance.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 09:27 |
pls help. mesh collapsed with dynamic mesh. | wlt_1985 | FLUENT | 2 | May 7, 2020 11:42 |
Incylinder dynamic mesh with volumetric reaction | mas | FLUENT | 4 | May 3, 2012 11:22 |
dynamic mesh on a hexa grid | Manoj Kumar | FLUENT | 0 | August 21, 2007 08:41 |
Dynamic mesh + grid adapt = Crash! (Files included | BillH | FLUENT | 4 | July 24, 2007 16:31 |