Gambit HEX core method gives unwanted 2D region

February 3, 2008, 05:21

Hi there,

I meshed one conical volume with Hexa-core method and it gave me a very GOOD quality HEX dominated mesh with few layers of pyramids and prisms around hexa.

But When I save the mesh in ANSYS format to import in CFX-11, I see that mesh contains a 2D primitive region right where pyramids start around the region of HEX elements. But I did not define or create this region in Gambit. I do not want to have this 2D region created at all because this gives me problem in CFX-11(It would fall under wall category).

1) I do not understand how come this 2D region exists. Any idea? Is it a problem with HEX-core scheme?

2)Is there any way out to get rid of this region?

3) Will saving the mesh in some other format work?

Thanks a lot in advance for your help !

Best Regards, KK

February 4, 2008, 09:31

i dont know CFX much,but principally you can manipulat mesh in CFX like in fluent(merging, split,...),(in CFX pre),right?maybe you should post you question in CFX Forum

February 3, 2008, 05:21	Gambit HEX core method gives unwanted 2D region	#1
KK Guest Posts: n/a	Hi there, I meshed one conical volume with Hexa-core method and it gave me a very GOOD quality HEX dominated mesh with few layers of pyramids and prisms around hexa. But When I save the mesh in ANSYS format to import in CFX-11, I see that mesh contains a 2D primitive region right where pyramids start around the region of HEX elements. But I did not define or create this region in Gambit. I do not want to have this 2D region created at all because this gives me problem in CFX-11(It would fall under wall category). 1) I do not understand how come this 2D region exists. Any idea? Is it a problem with HEX-core scheme? 2)Is there any way out to get rid of this region? 3) Will saving the mesh in some other format work? Thanks a lot in advance for your help ! Best Regards, KK

February 4, 2008, 09:31	Re: Gambit HEX core method gives unwanted 2D regio	#2
jesse Guest Posts: n/a	i dont know CFX much,but principally you can manipulat mesh in CFX like in fluent(merging, split,...),(in CFX pre),right?maybe you should post you question in CFX Forum

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
[ICEM] how can i create a consistent transitions between tet and hex? specifically my model?	snailstb	ANSYS Meshing & Geometry	3	March 15, 2010 20:26
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 08:19