 |
 |
 |
|
|
|
[Sponsors] | ||||
February 4, 2008, 12:45
|
Which turbulence model to choose?
|
#1 |
|
Guest
Posts: n/a
|
Hi folks,
was wondering if anyone can recommend any academic papers, articles or books which specify the advantages of certain models (e.g. k-epsilon, k-omega, RSM, etc)? I need to choose one for my university project, but need to back up my choice with valid reasons. hopefully someone out there can help. Regards, Si Del |
|
|
||
|
February 4, 2008, 13:27
|
Re: Which turbulence model to choose?
|
#2 |
|
Guest
Posts: n/a
|
Wilcox - Turbulence modeling for CFD.
|
|
|
|
||
|
February 4, 2008, 14:00
|
Re: Which turbulence model to choose?
|
#3 |
|
Guest
Posts: n/a
|
You should just look up the FLuent Documentation.
|
|
|
|
||
|
February 8, 2008, 04:24
|
Re: Which turbulence model to choose?
|
#4 |
|
Guest
Posts: n/a
|
There are two books which discuss turbulence modelling and give case studies and very good references. They are both introductory texts for CFD as a whole but WELL worth reading:
1) An introduction to computational fluid dynamics - the finite volume method. H. Versteeg, W. Malalasekra. 2nd edition is best. ISBN 0131274988 2) Computational Fluid dynamics - A practical approach - 2008, J. Tu. Good luck! Carlos. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Use of k-epsilon and k-omega Models | Jade M | Main CFD Forum | 40 | January 27, 2023 07:18 |
| Adding a Turbulence Model | doug | OpenFOAM Running, Solving & CFD | 11 | May 21, 2018 13:54 |
| question about turbulence model selection and sensitivity | karananand | Main CFD Forum | 1 | February 26, 2010 04:41 |
| Centrifugal Pump and Turbulence Model | Michiel | CFX | 12 | January 25, 2010 03:20 |
| SSG Reynolds Turbulence Model | Georges | CFX | 1 | February 28, 2007 16:15 |
Linear Mode
