Home > Forums > Software User Forums > ANSYS > FLUENT

Help: Heat transfer at interface

Mark Forums Read

Reply

Search this Thread

February 24, 2008, 14:59	Help: Heat transfer at interface	#1
jiang Guest Posts: n/a	Dear everyone, I am now studying the heat transfer phenomena in two fluids (A and B). Hope the following figures make things clear. ----------------------------------- A (Fluids) --------------------------- (same heat flux in two fluids ) B (Fluids) ---------------------------------- (wall) (T=0) Now the known conditions are (1) the wall temperature is given (T=0); (2) Heat flux at the interface of two fluids are the same, that is, h(b)dT/dn@interface = h(a)dT/dn@interface. How can we solve the problem in Fluent? Any comment is welcome. Thanks a lot! Jiang

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with mass transfer in heat and water vapor exchanger	mullenc525	CFX	7	January 25, 2011 23:26
Convective / Conductive Heat Transfer in Hypersonic flows	enigma	Main CFD Forum	2	November 1, 2009 22:53
increasing mesh quality is leading to poor convergence	tippo	CFX	2	May 5, 2009 10:55
How can I increase Heat Transfer at Domain Interf?	B.Simon	CFX	3	October 28, 2008 18:53
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

All times are GMT -4. The time now is 08:27.