DES wall treatment -- CFD Online Discussion Forums

March 5, 2008, 11:21	DES wall treatment	#1
a. Guest Posts: n/a	Hello, I am about to run a DES model of a confined flow. And I was wondering what kind of wall treatment does Fluent use? Is it simple log-law? This would be needed in order to know what mesh resolution is adequate at the wall. I was searching in the manual, but somehow cannot locate this info. Thank you for any suggestions or further reading/fluent related tips a.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh	Shoonya	OpenFOAM Meshing & Mesh Conversion	11	January 20, 2012 06:23
chtMultiRegionFoam near Wall Treatment/ Wallfunctions	stawrogin	OpenFOAM	0	March 18, 2010 14:36
Near Wall treatment	sven	OpenFOAM	1	September 13, 2009 20:57
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
Near wall treatment for k-e model	raik	Main CFD Forum	3	May 6, 2007 07:51

All times are GMT -4. The time now is 17:32.