|
[Sponsors] |
March 27, 2008, 09:36 |
interior angle problem
|
#1 |
Guest
Posts: n/a
|
Hi all,
i got the following Warning when trying to mesh (tetrahedral) a 3d volume : "interior angle of volume v_volume.1 for following edges is too large for side type boundary layer, which may generate poor elements" : v_edge.325 v_edge.325 is the trailing edge of a sailboat keel. The B.L. should go around the trailing edge but apparently doesn't. this warning is followed by an error : TG_mesh_Domain failed with error code 1. any idea (i can send an image if needed)? thanks Anthony |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Interior B.C. Problem | Samaneh Zeighami | FLUENT | 6 | September 8, 2012 05:06 |
a serious problem on a case with attack angle | anne | CFX | 0 | November 18, 2008 05:28 |
Divergence problem when airfoil exceed pitch angle | zonexo | Main CFD Forum | 2 | April 4, 2007 04:22 |
Tide angle problem when meshing | Tudor Miron | CFX | 4 | March 22, 2004 17:24 |
INTERIOR | Mike | FLUENT | 1 | December 23, 2003 15:05 |