|March 27, 2008, 11:36||
interior angle problem
i got the following Warning when trying to mesh (tetrahedral) a 3d volume : "interior angle of volume v_volume.1 for following edges is too large for side type boundary layer, which may generate poor elements" : v_edge.325
v_edge.325 is the trailing edge of a sailboat keel. The B.L. should go around the trailing edge but apparently doesn't.
this warning is followed by an error :
TG_mesh_Domain failed with error code 1.
any idea (i can send an image if needed)?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Interior B.C. Problem||Samaneh Zeighami||FLUENT||6||September 8, 2012 06:06|
|a serious problem on a case with attack angle||anne||CFX||0||November 18, 2008 06:28|
|Divergence problem when airfoil exceed pitch angle||zonexo||Main CFD Forum||2||April 4, 2007 05:22|
|Tide angle problem when meshing||Tudor Miron||CFX||4||March 22, 2004 18:24|
|INTERIOR||Mike||FLUENT||1||December 23, 2003 16:05|