|
[Sponsors] |
April 3, 2008, 13:45 |
Out of memory
|
#1 |
Guest
Posts: n/a
|
Dear Sir,
Many times when I give meshing command, GAMBIT shows out of memory message. Please let me know how to solve this problem? Is it related to RAM capacity? At present my PC has 1GB RAM. With regards. Sanjay Jain |
|
April 3, 2008, 18:10 |
Re: Out of memory
|
#2 |
Guest
Posts: n/a
|
Yeah you probably need to upgrade. Depending on how complex your models/mesh are 1GB can be far too small. Our previous machine kept crashing with 2GB.
|
|
April 4, 2008, 06:24 |
Re: Out of memory
|
#3 |
Guest
Posts: n/a
|
You can run on Win64 to get more memory access.
If meshes too large use TGrid as it is 64bit capable and generate up to about 100 million cells with a machine of =>128Gb RAM. |
|
April 4, 2008, 08:10 |
Re: Out of memory
|
#4 |
Guest
Posts: n/a
|
Thanks a lot for valuable reply. I will try your suggestions.
With regards Sanjay Jain |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Out of memory? | raintung | FLUENT | 6 | May 25, 2016 22:21 |
RAM memory | alpha | CFX | 1 | October 8, 2009 11:31 |
out of memory | dsunil | FLUENT | 7 | September 19, 2008 10:20 |
Out of Memory | Naghman Khan | FLUENT | 3 | August 30, 2007 06:08 |
Memory 400-667 MHz | George | Main CFD Forum | 8 | March 1, 2007 08:22 |