|
[Sponsors] |
April 18, 2008, 10:49 |
Gambit-Fluent
|
#1 |
Guest
Posts: n/a
|
Hi ! I'm trying to mesh a pipe (simple) with gambit. But when I verify the centre section in the Fluent, it appears some lines (diagonal lines) that would not have to be there. how I can change this?
|
|
April 18, 2008, 13:50 |
Re: Gambit-Fluent
|
#2 |
Guest
Posts: n/a
|
May be the node points you are giving at the centre is not in ordered check both the upper and the lower node points.
|
|
April 21, 2008, 07:40 |
Re: Gambit-Fluent
|
#3 |
Guest
Posts: n/a
|
how I make this?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit and Fluent Help | Vincent Ryan | FLUENT | 2 | January 11, 2009 07:34 |
New gambit and fluent | Anonymous | FLUENT | 1 | May 16, 2006 02:51 |
gambit-fluent | ocy | FLUENT | 4 | December 16, 2004 00:20 |
gambit in fluent | kostas | FLUENT | 5 | July 10, 2003 06:01 |
Fluent and Gambit | jack Keays | Main CFD Forum | 9 | September 1, 1999 19:39 |