Turbulent model properties for airfoil

May 24, 2008, 05:34

Hi,

I'm trying to solve in fluent flow around part of wing (dimensions:3x0.3x0.3) in 3D with Spalart-Allmaras turbulence model. On the velocity inlet I set turbulence intensity to 5% and lenght scale to 0.3. There where no problems with convergetion in small attack angle. For higher angles solution don't converge. Where could be a problem?

Regards, Michal

June 6, 2008, 09:59

Hi Mike,

Separation of flow occured (i.e. stall) for the higher angles of attack and it's no longer a steady flow over the wing?

Good luck.

p.s.: An airfoil is not a wing.

Also at higher angles of attack, you might want to try the SST k-w turbulence model.

May 24, 2008, 05:34	Turbulent model properties for airfoil	#1
Michal Guest Posts: n/a	Hi, I'm trying to solve in fluent flow around part of wing (dimensions:3x0.3x0.3) in 3D with Spalart-Allmaras turbulence model. On the velocity inlet I set turbulence intensity to 5% and lenght scale to 0.3. There where no problems with convergetion in small attack angle. For higher angles solution don't converge. Where could be a problem? Regards, Michal

June 6, 2008, 09:59	Re: Turbulent model properties for airfoil	#2
Kelvin Guest Posts: n/a	Hi Mike, Separation of flow occured (i.e. stall) for the higher angles of attack and it's no longer a steady flow over the wing? Good luck. p.s.: An airfoil is not a wing. Also at higher angles of attack, you might want to try the SST k-w turbulence model.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Airfoil in Stall - Turbulent model.	Jack	FLUENT	0	November 7, 2008 02:53
Airfoil turbulent separation	Seroga	Main CFD Forum	0	October 23, 2008 02:02
Turbulent airfoil setup	pvtpilot	OpenFOAM Running, Solving & CFD	5	July 2, 2007 19:14
simulation of a turbulent flow on airfoil	Dante	FLUENT	3	June 8, 2007 14:54
Airfoil: Laminar or Turbulent	Yap Wen Jiun	Main CFD Forum	3	March 12, 2000 11:31