CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   post processing problem (http://www.cfd-online.com/Forums/fluent/48366-post-processing-problem.html)

Charles May 29, 2008 06:37

post processing problem
 
Dear all, I finish a run and need to do post prcessing work on a zone. for example, make a contour plot at section in the zone. The problem is that how can I get the velocity or gradient(dt/dx or dp/dx etc) in the local coordinate system. would you please give me a hand. Thanks a lot in advance! Charles

jesse June 1, 2008 11:39

Re: post processing problem
 
display/define iso/surface, line,etc

Charles June 2, 2008 03:12

Re: post processing problem
 
Thanks for your attention. but the command you mentioned just make a surface from a zone. when doing processing work, the result on the surface is still based on the global coordinate. I need the result based on the local coordinate system. How can FLUENT do this work? Thanks again. Charles


All times are GMT -4. The time now is 23:34.