|
[Sponsors] |
May 28, 2008, 22:44 |
Does anybody uses Fluentusers.com at all?
|
#1 |
Guest
Posts: n/a
|
Like what my question asked, is there even anybody using the forums at Fluentusers.com at all? I went to visit that website recently and didn't see any forum entries at all.
|
|
May 29, 2008, 01:26 |
Re: Does anybody uses Fluentusers.com at all?
|
#2 |
Guest
Posts: n/a
|
To use this site you must get user name and password from your fluent agent and if your copy illegal or not have a license you cannot used it.
|
|
May 29, 2008, 02:01 |
Re: Does anybody uses Fluentusers.com at all?
|
#3 |
Guest
Posts: n/a
|
Yeah i know but recently i went in with the user name and password from my school but there was nothing inside at all.
|
|
May 29, 2008, 06:18 |
Re: Does anybody uses Fluentusers.com at all?
|
#4 |
Guest
Posts: n/a
|
what you looking for? if you have username & password try to check ansys site it contain some tutorials may of interest for you.
|
|
May 29, 2008, 22:22 |
Re: Does anybody uses Fluentusers.com at all?
|
#5 |
Guest
Posts: n/a
|
Haha yeah i passed my problem to them already. Mine was regarding some settings i chose in my simulation and i'm not too sure are they correct or not as they gave the results that i almost wanted except for some differences.
Basically i'm doing water in oil emulsion and when the water droplets are formed, they tend to be sticking onto the wall, which isn't what i expected as i thought they would be at the centre of the pipe. (The bubbles diameter are slightly smaller than that of the pipe.) So i'm not too sure whether it was some settings that i chose that caused this and i sent it to their technical support for help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fluentusers.com | naser | FLUENT | 3 | October 20, 2021 05:14 |