|
[Sponsors] |
June 5, 2008, 03:00 |
choose which pressure?
|
#1 |
Guest
Posts: n/a
|
The saturated vapor pressure of water is 4132.982Pa(30C),in ordor to judge whether the water evaporate or not ,which pressure would be choosen in"contours of",static pressure or absolute pressure.
|
|
June 6, 2008, 06:23 |
Re: choose which pressure?
|
#2 |
Guest
Posts: n/a
|
Hello,
I think you should use static pressure. I'm not quite sure about its definition, but for fluent absolute pressure is "operation pressure" + "gauge pressure" (http://www.engres.odu.edu/Applicatio...ug/node332.htm). And assuming that gauge pressure is in fact dynamic pressure, I then believe that it's not the pressure you're looking for. Just check if the results for static pressure is also relative to the operating pressure or they're absolutes. I hope I could make my self clear - and I'm not sure about that. My best regards, Victor |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to choose a BL dimensions..? | Cyril | FLUENT | 11 | September 21, 2007 08:42 |
how to choose Interface | prateek jain | CFX | 3 | July 11, 2007 23:56 |
Where can I choose RANS and RNG!!! | maoasis | FLUENT | 4 | May 2, 2006 17:19 |
Would someone help me choose? | Xiaozhu | Main CFD Forum | 7 | May 23, 2002 02:07 |
Which products should I choose? | jianxia | CFX | 1 | May 29, 2000 04:18 |