|
[Sponsors] |
June 11, 2008, 07:22 |
urgent-dividing inlet of 3d pipe
|
#1 |
Guest
Posts: n/a
|
I want to divide the inlet of 3 D pipe into two parts (not equal in areas) the pipe is symetric a long the vertical midplane as shown on the figure given in the following link: http://www.quickfiles.net/860919 I have no idea how I can doing it can anybody assist me with it? I appreciate any possible assist.
Thank in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BC - Simulating an open air inlet for a pipe. | Chris | CFX | 1 | January 10, 2007 13:10 |
2D Laminar Pipe Flow(Urgent) | tnpmember | CFX | 6 | January 9, 2006 05:40 |
outflow BC for closed pipe (no inlet) | tej | FLUENT | 1 | May 14, 2004 10:25 |
Heat Pipe-Urgent | TSL | FLUENT | 0 | December 9, 2003 21:21 |
* urgent help required for simulation of pipe flow | mei | Main CFD Forum | 3 | July 3, 2002 04:22 |