reported mass flow differs from monitored mass flo

July 14, 2008, 13:51

Hello

I am running a simple simulation which includes an inlet and an outlet. I am monitoring the mass flow rate on a graph as well as the residuals.

Once the solution has converged the reported mass flow rate on report>surface integrals> inlet /outet etc is considerably higher than the values which were being plotted on the graph.

Which one is correct and why is this happening?

Thanks

July 15, 2008, 02:46

Do you run solver and postprocessing both in double precision?

July 15, 2008, 04:13

Hello BastiL, I'm not sure what you mean when you say double precision?

Please explain?

Thanks

July 15, 2008, 08:19

surface integrals at inlet and outlet is correct if ur net mass flow rate is zero.. or very near to zero...

July 17, 2008, 12:44

When you start fluent ask for 2ddp (2 dimensions, double precision). If you used an old fluent version, writte

fluent 2ddp

on the terminal, good luck

July 14, 2008, 13:51	reported mass flow differs from monitored mass flo	#1
London Guest Posts: n/a	Hello I am running a simple simulation which includes an inlet and an outlet. I am monitoring the mass flow rate on a graph as well as the residuals. Once the solution has converged the reported mass flow rate on report>surface integrals> inlet /outet etc is considerably higher than the values which were being plotted on the graph. Which one is correct and why is this happening? Thanks

July 15, 2008, 02:46	Re: reported mass flow differs from monitored mass	#2
BastiL Guest Posts: n/a	Do you run solver and postprocessing both in double precision?

July 15, 2008, 04:13	Re: reported mass flow differs from monitored mass	#3
London Guest Posts: n/a	Hello BastiL, I'm not sure what you mean when you say double precision? Please explain? Thanks

July 15, 2008, 08:19	Re: reported mass flow differs from monitored mass	#4
ravi kumar Guest Posts: n/a	surface integrals at inlet and outlet is correct if ur net mass flow rate is zero.. or very near to zero...

July 17, 2008, 12:44	Re: reported mass flow differs from monitored mass	#5
jeremy Guest Posts: n/a	When you start fluent ask for 2ddp (2 dimensions, double precision). If you used an old fluent version, writte fluent 2ddp on the terminal, good luck

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mass flow rate of the DPM mass sourse ??	Rhinocao	FLUENT	3	January 21, 2011 12:10
volume fraction,mass fraction,bulk mass flow	nick	CFX	0	April 25, 2008 09:51
Mass flux and mass flow rate	us	Phoenics	10	March 31, 2006 02:06
volume fraction, Mass fraction and Bulk Mass flow	Dr.jones	CFX	1	January 25, 2006 04:32
How are the mass flux and mass flow rate defined?	Miles	Siemens	2	November 7, 2002 08:45