|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi all, I have a question on defining rightly the pressure term for a pressure outlet boundary condition. I am modeling natural convection within an enclosure with free openings to the outside. When I am asked to enter the ambient ( = outside the domain) pressure should I enter the hydrostatic head ( = - (density * g * opening height)) or this is not required as it is computed automatically by the software. Any help will be appreciated, Thanks in advance,
Giacomo |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
hi,
u can give 0 gauge pressure at outlet wen the flow is going to atmosphere. at the same time u have to give pressure inlet B.C give boussinesq law for density variation in material panel. use body force weighted for pressure equation. |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
hello giacomo
the reply by ravi to your problem is good one if you want to find the pressure drop you can give zero gauge pressure.and at the inlet you can specify the velocity inlet |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
What type of pressure can give the pressure drop | david | FLUENT | 1 | February 17, 2014 12:51 |
Pressure driven laminar flow simpleFoam pressure higher at the outlet than inlet | gabriel | OpenFOAM Running, Solving & CFD | 16 | September 30, 2009 19:20 |
Forcing pressure outlet according to pressure prob | Cedric | FLUENT | 0 | July 29, 2005 12:49 |
pressure driven flow by pressure correction method | justentered | Main CFD Forum | 0 | December 30, 2003 00:52 |
Total pressure to static pressure ratio | roadracer | Siemens | 1 | April 17, 2003 06:31 |