 |
 |
 |
|
|
|
[Sponsors] | ||||
Problem in importing Structured mesh from ICEM CFD to ANSYS FLUENT |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 31, 2020, 07:22
|
Problem in importing Structured mesh from ICEM CFD to ANSYS FLUENT
|
#1 |
|
New Member
Aravind M
Join Date: Sep 2019
Posts: 5
Rep Power: 6  |
Hi , Everyone.
i am working on a project titled "Cold flow analysis of swirl injector". I have successfully made a structured hexahedral mesh using ICEM CFD for the injector and when checked for quality, am getting pretty good results which ensures the mesh is of good quality. But when importing the mesh to Ansys Fluent for analysis,The software is showing a warning message saying " left-handed faces detected on Zone 13..." when I ignore the message and moved further, the solution is diverging at the 1st iteration itself and shows an error message saying the solution is getting diverged. Can anyone help me with this problem and to mention am a beginner to ICEM CFD am facing this problem for past 1 week and am stuck here. |
|
|
|
|
|
| Tags |
| diverged, hexahedral mesh, icem cfd meshing, left-handed faces, negative cell volume |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem occurring while importing mesh file in Fluent | RajG | FLUENT | 0 | June 2, 2015 09:30 |
| [ICEM] ICEM CFD Problem with the boundary conditions while importing the mesh to fluent | sonic109 | ANSYS Meshing & Geometry | 2 | September 3, 2014 00:56 |
| Ansys 14.5 Problem Import Mesh from ICEM CFD to CFX | Smiling Assassin | CFX | 1 | May 9, 2014 02:27 |
| [ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
| Importing ICEM mesh to Fluent | mr_stoked | FLUENT | 1 | June 25, 2010 03:24 |
Linear Mode
