CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Urgent! How to make a line contour and mark number (http://www.cfd-online.com/Forums/fluent/49026-urgent-how-make-line-contour-mark-number.html)

Thanh August 16, 2008 12:10

Urgent! How to make a line contour and mark number
 
Dear Fluent Users,

I want to make a figure of line contour of temperature by Fluent and I wan to mark number on each line. But I can not find any option in Fluent to do so.

Can anyone give me some suggestions on doing this?

Thanks so much in advance,

Best regards,

Thanh

yong August 19, 2008 22:54

Re: Urgent! How to make a line contour and mark nu
 
Hello, Thanh I think you can use TECPLOT(a software for postproceeding) to do this.

Best wishes! Yong


Thanh August 20, 2008 13:25

Re: Urgent! How to make a line contour and mark nu
 
Hi, Yong, Thanks for your suggestion. But there are some problems when I load fluent data in TECPLOT. It seems that the scale of the 3D Cartesians is not idential. The other problem is that I can not make a contours of a variable at a certain cross section. Can you give me some more suggestion on solving that? Thanks a lot in advance

Thanh


All times are GMT -4. The time now is 00:04.