CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   In reply to: "only one adjacent cell thread." (http://www.cfd-online.com/Forums/fluent/49115-reply-only-one-adjacent-cell-thread.html)

Krystian August 27, 2008 21:39

In reply to: "only one adjacent cell thread."
 
I tried to add my two words to following post, but I couldn't find a way to do it - I think it is too old. http://www.cfd-online.com/Forum/flue...cgi/read/26492

Nonetheless, I encountered the same problem. Jason explains it well. However, before defining interface one needs to go to Define -> Boundary Conditions, choose the internal edges which couldn't be interpreted as INTERIOR and re-assign the INTERIOR boundary condition. If Fluent cannot read it, it will assign WALL boundary condition by default. After assigning INTERIOR proceed as Jason describes.

Regards,

Krystian


All times are GMT -4. The time now is 07:32.