2D TANK IN GAMBIT

October 6, 2008, 09:04

I am not able to save and exit a 2D Tank mesh in Gambit. Moment i give the boundary conditions,save and exit gambit, error message comes as these boundary conditions not suitable for fluent 6.

My tank dimensions are 1mx1m square with inlet (05 mm dia ) at right wall(20mm from bottom). Outlet is 4mm dia on top wall at distance of 10 mm from left wall.

Request assistance on Meshing and Boundary conditions. I am working this model for mixture model(liquid-liquid flow)

October 7, 2008, 12:49

have you selected solver fluent 5/6 ?

October 6, 2008, 09:04	2D TANK IN GAMBIT	#1
vinay Guest Posts: n/a	I am not able to save and exit a 2D Tank mesh in Gambit. Moment i give the boundary conditions,save and exit gambit, error message comes as these boundary conditions not suitable for fluent 6. My tank dimensions are 1mx1m square with inlet (05 mm dia ) at right wall(20mm from bottom). Outlet is 4mm dia on top wall at distance of 10 mm from left wall. Request assistance on Meshing and Boundary conditions. I am working this model for mixture model(liquid-liquid flow)

October 7, 2008, 12:49	Re: 2D TANK IN GAMBIT	#2
costel Guest Posts: n/a	have you selected solver fluent 5/6 ?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sliding mesh setup for a mixing tank in Gambit	nycera	FLUENT	13	October 11, 2016 14:39
Gas discharge from tank to tank through a pipe	Arno	FLUENT	4	December 28, 2010 09:52
Filtration in a tank	Fran	FLOW-3D	3	February 8, 2009 23:21
SPH tank........help!!!!!!!!!!	GaoRui	Main CFD Forum	0	May 24, 2007 04:13
MixSim to Gambit (Mixing Tank)	Eric R.	FLUENT	2	April 17, 2002 09:35